Burkert Type TAT002 Bedienungsanleitung PDF herunterladen (Seite 13)

0911 - 11

english

HEATING

Parameter S1C = in; The value HY has been preset to 2 K in the factory.

If the temperature falls below the value SET-HY, the controller output will be

switched on and will be switched off again when SET is exceeded.

2.5 Controlling the loads

CONTROLLER OUTPUT

The control is dependent on the measured temperature (= sensor

temperature). Program the control direction (heating or cooling) with the

parameter S1C.

S1C = dir Cooling SET = Set-value

S1C = in Heating Hy = Switch hysterisis

COOLING

Parameter S1C = dir; The value HY has been preset to 2 K in the factory.

If the temperature exceeds the value SET + HY, the compressor will be

switched on and will be switched off again when the temperature is below SET.

temperature

SET

SET-HY

heat

temperature

compressor

SET

SET+HY

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Keine Kommentare

Burkert Type TAT002 Bedienungsanleitung Seite 13