Burkert Type S030 Bedienungsanleitung PDF herunterladen (Seite 7)

50 x DN 5 x DN

40 x DN 5 x DN

25 x DN 5 x DN 20 x DN 5 x DN

18 x DN 5 x DN 15 x DN 5 x DN

With control valve

Pipe with 2 elbows

at 90°

Pipe with 2 elbows at 90°

in 3 dimensions

Pipe with 1 elbow at 90°

or 1 T-piece

With pipe expansion

With pipe

reduction

Fig. 2: Upstream and downstream distances depending

on the design of the pipes.

→ Use a flow conditioner, if necessary, to obtain the best

accuracy.

English

→ Prevent the formation of air bubbles in the pipe (see

Fig. 3).

→ Ensure the pipe is always filled with liquid (see Fig. 4).

Correct

Incorrect

Direction of fluid flow

Fig. 3: Additional recommendations on installation

English

Correct

Incorrect

Correct Incorrect

Fig. 4: Additional recommendations on installation

Installing a fitting with weld ends

Follow the previously described general installation

recommendations.

English

note

The seal on the fitting with weld-end connections

may be damaged during welding.

→ Before welding the weld-ends, unscrew the 4 tight-

ening screws.

→ Remove the sensor holder.

→ Remove the seal.

→ Weld the weld-ends.

→ After welding, correctly replace the seal in the

groove.

→ Replace the sensor holder.

→ Tighten the 4 screws in an alternating pattern, app-

lying a nominal tightening torque of 1,5 Nm.

English

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare

Burkert Type S030 Bedienungsanleitung Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Burkert Type S030