Burkert Type 8112 Bedienungsanleitung PDF herunterladen (Seite 18)

5 Open the terminals with a screwdriver

6 Insert the wire ends into the open terminals according to the wiring

plan

7 Tighten the terminals with a screwdriver

8 Check the hold of the wires in the terminals by lightly pulling on

them

9 Tighten the compression nut of the cable entry. The seal ring must

completely encircle the cable

10 Screw the housing cover back on

The electrical connection is ﬁnished.

5.3 Wiring plan, single chamber housing

N A M U R

( I E C 6 0 9 4 7 - 5 - 6 )

m a x .

m i n .

S i m u l .

+ -

0,5 g / cm

0,7 g / cm

Fig. 10: Electronics and connection compartment, single chamber housing

1 Control lamp

2 DIL switch for characteristics reversal

3 DIL switch for sensitivity adjustment

4 Ground terminal

5 EMC ﬁlter element

6 Simulation key

7 Connection terminals

For connection of the ampliﬁer according to NAMUR (IEC 60947-5-6,

EN 50227). You can ﬁnd further information in the "Technical data".

Electro

nics and connec-

tion compartment

Wir

ing plan

18 LEVEL SWITCH 8112 • with NAMUR output

5 Connecting to power supply

32052-EN-120418

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 111 112

Keine Kommentare

Burkert Type 8112 Bedienungsanleitung Seite 18